In the trombone realm practice mutes are basically all good (okura/ best brass/ ben van dijk). Not so for tuba’s!! Is it that hard to design a practice mute that is in tune and actually is silent? I have schlipf now, it is doable but the tuning really sucks apart from the midrange.
I would think a basic design with a very large volume (large bulb past the bell) in light weight printed material could work. Ideally would like to buy a CAD design that I can have printed locally. This basic CAD design could be adjusted for any bell size and bell throat diameter.
No? Yes?
3D printed practice mute?
Forum rules
This section is for posts that are directly related to performance, performers, or equipment. Social issues are allowed, as long as they are directly related to those categories. If you see a post that you cannot respond to with respect and courtesy, we ask that you do not respond at all.
This section is for posts that are directly related to performance, performers, or equipment. Social issues are allowed, as long as they are directly related to those categories. If you see a post that you cannot respond to with respect and courtesy, we ask that you do not respond at all.
Re: 3D printed practice mute?
Large format 3D printers (~325 mm³) are becoming more accessible now, before it was either high end professional ($$$) or entry level hobbyist machines.
To work out a good design you need someone with a large format printer that can iterate and fine-tune the design.
Scaling up a trombone design could be a good start
To work out a good design you need someone with a large format printer that can iterate and fine-tune the design.
Scaling up a trombone design could be a good start
Re: 3D printed practice mute?
That is good to know the printing possibilities are there.
I am not so sure if a scale up of a trombone mute is going to work. On the other hand: one big difference I think I see is that the trombone mute follows the bell profile much closer than the schlipf on my tuba
I am not so sure if a scale up of a trombone mute is going to work. On the other hand: one big difference I think I see is that the trombone mute follows the bell profile much closer than the schlipf on my tuba